MobileHome

Fibaro Smart Module

PrintEmail
Array
Sales price without tax 62,04 €
Tax amount 14,89 €
Addition Επιπλέον

 

With the FIBARO Smart Module, you can integrate existing electrical installations (e.g. lighting, airing systems…) into a Z-Wave network. Thus, the connected devices can still be controlled with the existing wall switch, but – thanks to Z-Wave – also via remote control, smartphone or sensor-controlled automation.

The compact radio module is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as input device for the FIBARO insert that is controlling the load. The switch only sends control signal to the insert which controls the load then again. The solution works with all switch design. You can use a momentary or a toggle switch. It’s recommended to use wall boxes with 65mm depth. But smaller boxes with only 45mm depth can be used also if there is enough space behind the switch. The available space depends on the size of the traditional switch, the dimensions of the wall box and the amount of additional cabling placed in this box.

Features:

    • Radio module for wall box installation
    • Rated load current: 6.5A in single version
    • Power supply: 100-240 VAC ~ 50/60 HZ or 24-30VDC
    • Wireless Technology: Z-Wave Plus
    • S2
    • SmartStart

 

IP20, Z-Wave Plus, Z-Wave S2.

 

You can use the euFIX S214 Adapter to install the FIBARO® Switch FGS-214 module on DIN TH35 type rail in your electrical switchboard. The euFIX S214 Adapter consists of the case and the base board, where the FGS-214 module is mounted. The dimensions of the case are appropriate for a standard DIN TH35 type rail. The base board contains a set of screw terminals, where you can safely connected all the wires (power supply, input and output signals, control push-buttons). The front panel of the case contains two diagnostics micro-push-buttons S1 & S2, which you can used to control or to register the FIBARO® module within your Z-Wave system. Also you can remove it from the system without opening the adapter's case.

Specifications:

  • Suitable for FIBARO® FGS-214
  • Supply voltage: 230V, 50/60Hz
  • Load power: max 6.5 A (resistive load)
  • Dimensions: 34.8 x 87.3 x 64.7 mm
  • Conductor wires cross section: max. 2.5 mm2
  • Operating temperature: 0 °C to +35 °C
  • Relative humidity: ≤95 %, no condensation